Acoustic Door Seals - 3/16"x1/2"x50'

Looking to block sound from entering or exiting your space? Don’t forget about your doors!

	1. Measure the width and height of your door. Cut (3) strips of the Door Acoustic Seal to size (You'll need one for the top of your door as well as one for each side).
	2. Begin in the corner of your door, on the INSIDE of the frame - adhere each Door Acoustic Seal flush against the door jamb (See NOTE below). Peel off the paper backing as you go. (Helpful Hint: Open your door and stand on the side towards which it opens - you'll be facing the inside of the door frame).
	NOTE: On the hinge side of the door, the acoustic seal should be adhered NEXT to the door jamb, directly on the frame (see picture to the left). On the opposite side, the Door Acoustic Seal should be adhered directly ON TOP of the the door jamb. (see picture to the right)
	3. Once the Acoustic Door Seals have been adhered, run the flashlight test to ensure that no gaps remain. Simply shine a light through the top and sides of your door. If light shines through, you may want add another layer of the Door Acoustic Seal because this means there is still air space between the door and frame where sound can travel.

• Density (lbs./cu. ft.) ASTM D-1667 8#
• Hardness (Shore 00) ASTM D-2240 25
• Force to Compress (psi) ASTM D-1667 3.5 @25% (kPa 24)
• Compression Set 30% ASTM D-1667 5 (% loss from original height)
• Peel Adhesion ASTM D-1000 2#
• Water absorption GTP 1.0 (% by volume)
• Tensile Strength (psi) ASTM D-412 30 (kPa 207)
• Percent Elongation ASTM D-412 150
• Thermal Conductivity ASTM C-518 0.27
• Recommended Service Temperature -40°F to 180°F (-40°C to 80°C)
• Recommended Application Temperature 50°F to 110°F (10°C to 45°C)
• Fungi resistance - Excellent
• Oxidation resistance - Excellent
• Weather resistance - Excellent